Draper 503021 User Manual download pdf (Page 13)

EZ-Fold Basketball Backstops by Draper

Page 13 of 18

www.draperinc.com

(765) 987-7999

➇

Assemble and attach Height Adjuster or Goal Brace

(SWD), Bank, and Goal.

➀

Bolt Goal to Bank and Goal Brace (Direct Mount Goal Brace on

SWD).

NOTE: You cannot use a Goal Brace and Height Adjuster on the same

backstop.

TIP: Assemble Bank/Goal/Height Adjuster/Goal Brace face down on

sawhorses, then hoist and attach.

A0354 DGW Short Bank Banger

(for side away from direction of fold)

"-18 x 1

Cap Screw,

Lock Washer

"-18 x 1

Carriage Bolt,

Flat Washer,

Keps Nut

(See separate instructions for Height Adjuster assembly.)

SW, DGW, and DUW Goal attachment.

SWD Goal and Goal Brace attachment.

DUW Leg-to-Bank Assembly attachment.

DUW Inner Leg

"-20 x 2

Cap Screw,

Hex Nut

Mounting Lug from Ban

Hanger or Height

Adjuster Assembly.

NOTE: Use lift to raise and attach Bank Assembly.

"-18 x 1

Cap Screw,

Lock Washer

"-18 x 1

Cap Screw,

Flat Washer,

Keps Nut

Bolts (4),

Washers (4),

Nylon Lock Nuts (4)

Goal

Bank

Bolts (4),

Washers (4),

Nylon Lock Nuts (4)

Goal

Bank

Direct Mount

Goal Brace

SWD/SW Leg-to-Bank Attachment

DGW Leg-to-Bank Assembly attachment.

/2"-20 x 2

/2"

Cap Screw,

Hex Nut

DGW Inner Leg

Mounting Lug from

Bank Hanger or

Height Adjuster Assembly

SWD Direct Goal Brace-to-Bank attachment.

Attention: On glass backboards, Goal Plate Bushings are

properly tightened during factory assembly. Installer should

never tighten these bushings as excessive torque may cause

damage to the glass.

Caution: The maximum recommended torque when attach-

ing the goal to the backboard is 60 ft/lbs. Exceeding 60 ft/lb of

torque could cause damage to the backboard.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Draper 503021 User Manual Page 13

Comments to this Manuals