Draper GD13/5C Owner's Manual

DRILL PRESS STOCK No.65028 PART No.GD13/5C• INSTRUCTIONS •IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THESAFE A

- 9 -ASSEMBLY4. Ease table bracket and rack all the way downonto the column. Replace collar ✳✌ and re-tighten the grub screw, locking rack ✴✌ intopl

ASSEMBLY8. Screw the three downfeed handles ✻✌ intothe three holes located in the pinion shaft asshown in Fig 8.9. Making sure that the chuck ✼✌is

OPERATION AND USENO-VOLT ON/OFF SWITCH: (Fig 12)The drill is fitted with a no-volt switch with anemergency shut-off cover ❃✌.In the event of an emerg

- 12 -OPERATION AND USESPINDLE SPEEDSFive spindle speeds of: 600, 890, 1360, 2016,and 2800rpm are available with your drill. Thehighest speed is obtai

OPERATION AND USE1. The table ✰✌ Fig. 17 can be raised orlowered on the drill press column byloosening the table clamp handle ✱✌ andturning the tabl

OPERATION AND USEADJUSTING SPINDLE RETURN SPRINGFor the purpose of automatically returning thespindle upward after the hole has beendrilled, a spindle

The following directions will give the inexperienced operator a start on common drill pressoperations. Use scrap material for practice to get the feel

The following accessories are available from your local Draper stockist.DRILL PRESS VICESPART No.DPVManufactured from cast iron with fully hardened ja

NOTES- 17 -

- 18-NOTES

DRILL PRESS STOCK No.65028 PART No.GD13/5CCONTENTS:Page No.Declaration of Conformity...

DRAPER TOOLS LIMITED,Hursley Road, Chandler's Ford, Eastleigh, Hants. SO53 1YF. U.K.Helpline: (023) 8049 4344.Sales Desk: (023) 8049 4333.General

SPECIFICATION- 2 -The Draper Tools policy of continuous improvement determines the right to changespecification without notice.GD13/5C6502813mm13mmMT2

- 3 -CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V)To eliminate the possibility of an electric shock your machine has been fitted with a BSapprov

- 4 -GENERAL SAFETY INSTRUCTIONSFOR POWER TOOLS1. KNOW YOUR POWER TOOLRead and understand the owner's manual and labelsaffixed to the tool. Lear

1. This drill press is intended for useonly with drill bits. The use of anyother accessories may be hazardous.2. CHECK to see that the drill bit issec

- 6 -UNPACKING AND CHECKING CONTENTSCarefully unpack the bench drill and all loose items from the carton. Illustrated belowis the bench drill and all

- 7 -GETTING TO KNOW YOURDRILL PRESS✕✌MOTOR ✕✔✌TABLE LOCKING HANDLE✖✌PULLEY COVER ✕✕✌COLUMN✗✌MOTOR PULLEY ✕✖✌BASE✘✌SPINDLE PULLE

ASSEMBLYASSEMBLING THE DRILL PRESS1. Secure column ✪✌ to base ✫✌ using thefour bolts ✬✌. Loosen grub screw andremove collar ✭✌ along with the rack