Draper 503023 User Manual download pdf (Page 6)

EZ-Fold Basketball Backstops by Draper—Wall-Mounted

Page 6 of 17

www.draperinc.com

(765) 987-799

Joint Pins

(Not on all models)

➅ Attach pads using appropriate screws (three sizes provided).

Make sure all washers and lock washers are used, to avoid

loosening.

➆ If needed, trim for goal clearance. (Some backboard and goal

combinations will require extra trimming of pads to provide for

goal clearance.)

➄ IF PROVIDED: Use joint pins in pad half ends to eliminate

sagging.

➃ Drill holes (min imum

/4", maximum

/16") at marked locations.

Drill completely through all framework structure.

A0253/A0264 (glue-on:)

➀ Hold each half of pad in place and mark pads for trimming around

support structure (if required).

➁ When required trimming is complete, apply coat of glue to inside

of padding. Allow glue to dry until it becomes tacky (less than a

minute).

➂ While glue is drying on padding, apply a coat to the backboard.

➃ Attach padding to backboard.

A0142 (bolt-on)

➀ Hold each half of pad in place and mark pads for trimming around

support structure (if required).

➁ Trim pads.

➂ Hold pads in proper po sition and mark holes for drilling into board

frame work (8 holes per backboard). Make sure the holes closest

to the center of the backboard (under the rim) are positioned so

that the pads join fully in the middle.

CAUTION: On all glass or acrylic backboards, use holes nearest

the rear of the backboard to avoid pos sible damage.

Padding

Joint Pins

Backboard padding.

NOTE: This step can be completed at any point during installation;

the most convenient time is during bank/goal as sembly, prior to bank

attachment.

Nearest to

back for glass

and acrylic

backboards

➀ Touch up any scratches caused during installation or shipping.

➁ Remove tools and scrap from job site.

➂ Ensure all backstops are level and in accordance with measure-

ments on project drawings.

➃ Tighten all bolts, and ensure that backstops are ready for use.

➄ Verify that all backstops are functioning properly.

➅ Set all limit switches on electric winches.

➆ Coat Inner Tubes of Height Adjusters with petroleum jelly.

➇ Make sure all chalk lines are wiped from ﬂ oor.

➈ Dispose of boxes and packing materials.

➉ Explain proper winch and backstop maintenance and operation

to the customer.

Before leaving the jobsite:

NOTE: If you encounter any difﬁ culties installing or ser vicing your

EZ-Fold® Wall-Mounted Backstop by Draper, Inc., contact your

dealer or Draper, Inc. at (765) 987-7999; fax (765) 987-7142; e-mail

[email protected].

CAUTION

Glue used to attach Draper backboard pad ding is extremely

ﬂ ammable. Keep away from heat and ﬂ ame. Keep out of reach

of children. Avoid prolonged ex posure to fumes: Use in a well-

ventilated area.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comments to this Manuals

No comments

Draper 503023 User Manual Page 6

Comments to this Manuals

Related products and manuals for Music drums Draper 503023